All Validators are set up in the Validator Setup Activity.  They are used to validate manual and EDI Bills as well as Tenant Bills.   This section details the Tenant Bill Validators.

The Tenant Billing (TE) validators apply to Tenant Billing only and are set up at the Tenant Account or Organisation level, NOT the Site.

Tenant Bill Validation

From the Welcome page:

• Click on Validator Setup

Validator Setup Activity

Further information on Tenant Billing Validators

Click on the links below for more information on each Validator, including how to set up and then understand the failed validation.

• TB - ActualReadsAgeCheck.xml

  • Checks to see that the Meter Readings used from the Non Periodic Channel are within a certain age (as determined in the Validator set up)

• TB - AlignedBillStartReadsCheck.xml

  • Checks the Start Reading follows on from the End Reading on the previous Issued Billed

• TB - AlignedBillEndReadsCheck.xml

  • Checks the End Reading on this bill is the same as the Start Reading on the next bill

• TB - HfdChannelGapCheck.xml

  • Checks for any gaps in Periodic Channel Data

• TB - ZeroConsumptionCheck.xml

  • Alerts you if the consumption value is zero

• TB - totalConsumptionTol.xml

  • Checks that the total consumption on this bill is within a specified percentage of the previous issued bill

• TB - totalConsumptionTolYear.xml

  • Checks that the total consumption on this bill is within a set percentage of the previous years bill

• TB - totalConsumptionTolYearZeroCheck

  • Checks zero consumption on this bill/ last years bill

• TB - totalConsumptionTolZeroCheck 

  • Checks zero consumption on this bill/ previous bill

Setting up a Tenant Billing Validator

To set up a Tenant Billing Validator:

...