All Validators are set up in the Validator Setup Activity. They are used to validate manual and EDI Bills as well as Tenant Bills. This section details the Tenant Bill Validators.

The Tenant Billing (TE) validators apply to Tenant Billing only and are set up at the Tenant Account or Organisation level, NOT the Site.

Tenant Bill Validation

From the Welcome page:

Click on Validator Setup

Validator Setup Activity

Further information on Tenant Billing Validators

Click on the links below for more information on each Validator, including how to set up and then understand the failed validation.

TB - ActualReadsAgeCheck.xml
- Checks to see that the Meter Readings used from the Non Periodic Channel are within a certain age (as determined in the Validator set up)

TB - AlignedBillStartReadsCheck.xml
- Checks the Start Reading follows on from the End Reading on the previous Issued Billed

TB - AlignedBillEndReadsCheck.xml
- Checks the End Reading on this bill is the same as the Start Reading on the next bill

TB - HfdChannelGapCheck.xml
- Checks for any gaps in Periodic Channel Data

TB - ZeroConsumptionCheck.xml
- Alerts you if the consumption value is zero

TB - totalConsumptionTol.xml
- Checks that the total consumption on this bill is within a specified percentage of the previous issued bill

TB - totalConsumptionTolYear.xml
- Checks that the total consumption on this bill is within a set percentage of the previous years bill

TB - totalConsumptionTolYearZeroCheck
- Checks zero consumption on this bill/ last years bill

TB - totalConsumptionTolZeroCheck
- Checks zero consumption on this bill/ previous bill

Setting up a Tenant Billing Validator

To set up a Tenant Billing Validator:

Click
Change the Type to Tenant bill
Click on the Definition dropdown to see the available Validators:

Further Information

Click here for general information on setting up Validators.

Browser not supported