GB – AdvancedConcurrentReads

An advanced version of GB – ConcurrentReads and is used to identify overlapping invoices. Checks to make sure the meter readings follow on and can be set to ignore if there are gaps within the billing.

GB – BillConsumptionAgainstHHMeters

Compares the consumption on the bill against the metered consumption in the Periodic Channel

GB – BillReadsAgainstSelfReadChannel

Compares the invoice meter readings against meter readings entered into Non-Periodic Channels.

GB – ConcurrentReads

Checks that the meter readings entered in the current bill follow on from previous bill.

GB – ConsecutiveEstimates

Fails an invoice if the specified number of consecutive estimates is reached.

GB – ConsumptionOnBillLastBillZero

Checks if there is consumption on the current bill, but the previous bill has zero consumption. The Validator looks at the consumption figure, not the cost.

GB - TotalConsumptionTol

Checks the consumption in the current bill is within a percentage of the previous bill

GB – TotalConsumptionTolYear

Checks the consumption in the current bill is within a percentage of the previous years bill

GB - totalConsumptionTol(lower only)

Checks the total LOWER consumption in the current bill is within a specified percentage of the previous bill

GB - totalConsumptionTol(higher only)

Checks the total HIGHER consumption in the current bill is within a specified percentage of the previous bill

GB – DailyConsumptionTol

Checks the average daily consumption in the current bill is within a percentage of the previous bill

GB – DailyConsumptionTolHIGH

Checks the average daily consumption in the current bill is HIGHER than the previous bill (using a specified percentage)

GB – DailyConsumptionTolYear

Same as GB – dailyConsumptionTol but instead of checking against the previous bill, this validator checks this bill against the previous years bill (allows for better benchmarking)

GB - ElecBilledEnergyvsMeteredEnergyPct

Compares the billed units to the DUOS metered units. The billed units should be higher as they include losses.

GB – ElectricityEstimatedDataCheck

Checks for an estimated bill on an Electricity Account where the Supply Point Profile Class is either 00, 05, 06, 07 or 08 (half hourly metering).

GB – ExcessiveNonConsumptionCost

Checks bills for excessive electricity non consumption based charges such as standing charges. It will fail validation if the standing charges are greater than those on consumption charges – a tolerance can be applied.

GB – ZeroConsumptionCheck

Checks to see if there is any consumption on the current bill. It will fail if the invoice has no consumption. Normally set as an information only validator.

Browser not supported